Discrepancy tracking. Component Tracking by Cycles, Hours and Calendar for Retire, Overhaul or Inspections. Maintenance Tracking for AD’s, SB’s & Inspections by Hours, Months, Days & Cycles. Check For AD's (FAA Airworthiness Directives). Projected Maintenance Budgeting. Report will send an e-mail to your service provider showing Inspections due, Component Requirements and Discrepancies. For scheduling Service.

Component requires part number, description and serial number. Also required hours/cycles on the aircraft when the component was installed and the date that it was installed. History: hours/cycles & months/days on the component prior to install.
Last complied with hours/cycles and date. Adding / editing a limit for a component is very straightforward.
First is the frequency: hours, months, days or cycles. Next is the description: scheduled, O/C, cycle names, AD, SB, hours and the option to add your own.
Last is the action for the limit. Retire, inspection, overhaul or on condition. The alert sets the notification time when you will be notified. 25 hour alert will flag the item when your remaining time is within the alert time you set. Comply with maintenance or component limits is very straightforward.
Touch the Comply With Limit button and it shows the current hours or cycles and date for the item to change or not. Touch continue and the hours and date are highlighted. Touch accept and the last complied with hours and date will reset along with the remaining and current time.

Maintenance items require the requirement and description. The WWW Link is the link to the FAA or the manufacturer.
Adding / editing a limit for a maintenance requirement is very straightforward.  First is the frequency: hours, months, days or cycles.
Next is the description: scheduled, O/C, cycle names, AD, SB, hours and the option to add your own.
Last is the action for the limit. Retire, inspection, overhaul, or on condition. Also required is the last complied with date and hours or cycles.
The alert sets the notification time when you will be notified. 3 month alert will flag the item when your remaining time is within the alert time you set.
Comply with maintenance limits is very straightforward. Touch the Comply With Limit button and it shows the current hours or cycles and date for the item to change. Touch continue and the hours and date are highlighted. Touch accept and the last complied with hours and date will reset along with the remaining and current time.
 

Discrepancies are problems that you encounter, for instance an oil leak a bad light bulb or even serious items. when you send the report to your service center the discrepancies will be included in the report. Status indicates the discrepancy is pending or complete. Priority is low, medium or high.

 

Cycles and Hours is the key to CompuTrak, this is the basis of calculations for maintenance requirements and component life items.
For accurate and useful maintenance alerts, CompuTrak must have current hours and cycles data. Aircraft projection report: set date, hours and cycles ahead and recalculate then check your alerts and send the report to yourself for reference. Be sure and reset Hours and Cycles.
 

Select the aircraft from the list provided and enter the registration number, serial number and the hours currently on the aircraft. The date will be the default installed at date for components. Go thru each component limit and enter the required data. I.e. History: hours/cycles & months/days on the component prior to install, Last complied with hours/cycles and date and serial numbers. The next screen is Hours & Cycles. Add any cycles you need such as Starts. Multi engine needs Start1, Start2 etc. When finished with each cycle, touch 'Update Limits for all'  If your aircraft is not in the list, select blank to create your own aircraft. Touch accept to Proceed to add components and requirements.

 

    Request Technical Support or Suggestions.      tcallen@computrak.org